When installing flooring or a raised deck in an attic, there are three things to look out for which might otherwise slow you down or, worse, make the deck unsafe.


Irregularly-spaced joists

Irregularly-spaced joists or chords are a very common problem in attics. Most buildings have joists that are roughly either 16“ (400mm) or 24“ (600mm) apart. This dimension has however never been crucial to builders, who often put the joists or trusses in only roughly the right place, even in new properties. But attic decking boards come in standard sizes, usually around 4 ft. (1200mm) or 8 ft. (2400mm) long. So if your joists are too close together, then your boards will overhang a joist, which means you’ll have to cut the boards if you want to fit two of them together – and cutting boards is a messy and awkward job to undertake in an attic. Even worse, if the joists are too far apart, your boards simply won’t reach the final joist, which means that you cannot screw the board into that joist, and your deck will be unstable. Even a small difference on each joist makes a big gap when it comes to the end joist.

LoftZone StoreFloor uniquely solves this problem, with a completely different design. StoreFloor’s patented innovation is to use galvanised steel Cross-Beams that sit above the insulation and can have their position adjusted by up to 3”, precisely to provide flexibility in case of Irregularly-spaced joists. The boards then sit transversely on top of the Cross-Beams.

It’s a simple design feature that deals with Irregular joist spacing, and makes the raised deck easy and fast to install.

Uneven joists heights

Another problem, especially in older properties, is that some joists are higher than others. This could be because they were put in like that, because they have warped over the years, or simply because the wood used at the time was uneven in the first place. This causes a problem to anyone laying boards on the joists, as it means the deck cannot be flat. When raising a deck above the insulation, again it means that the deck won’t be flat either.

LoftZone StoreFloor uniquely solves this problem, with a completely different design. StoreFloor’s Cross-Beams need only be supported at each end, and therefore span over typically one or two joists in-between, without anything touching those joists. This means that, so long as you do a little bit of planning before installing the component parts, it is usually possible to identify any uneven joists and completely miss these out altogether. It’s a simple design feature that deals with uneven joist heights, and makes the raised deck easy and fast to install.

Obstructions

The third major issue in an attic is that there are often things that get in the way. Water tanks, trusses, air conditioning units, king pins, pipes and electrical cabling can all obstruct decking in the attic. No system can magic away all of these issues, and sometimes if you want to board in an area with obstructions, you will have to cut the boards around the offending item.

LoftZone StoreFloor does however have one major advantage over other systems, because it can span over obstructions fixed to joists. As described above, with StoreFloor you completely miss out many joists. So if you have a joist that has a pipe or other obstruction fixed on to it, then plan your deck to simply miss it out altogether. No other system can get around this problem without removing the obstruction.

Why Insulate Your Attic?

25% Heat is lost through your roof

Heat rises, and if you don't insulate your attic, 25% of your heat goes straight out of your roof. Source - Energy Savings Trust.

Watch a short video about why squashed insulation is a major problem